How do I fix a LaserLyte device that will not turn on?
Answer
Reinstall fresh batteries with correct polarity, reseat the battery cap until it is fully tight, and test the power switch. If it stays completely dead, the switch or battery compartment likely needs manufacturer service or replacement.
Before you start: stop right away if…
- Never point a laser at people, pets, vehicles, or aircraft.
Follow these steps
Reinstall batteries with correct polarity
Remove the batteries, confirm the + and - orientation marks, and reinstall fresh batteries carefully.
You should see: Batteries are seated correctly with matching polarity.
Reseat the battery or switch cap
Remove and reinstall the battery cap or switch cap so the threads seat cleanly and tighten fully.
You should see: The cap is snug and makes solid contact.
Test the power switch several times
Toggle or press the power switch firmly several times while watching for any beam or indicator.
You should see: The unit powers on intermittently or stays dead, narrowing the fault to the switch.
Seek manufacturer service if still dead
If new batteries, clean contacts, and a fully seated cap still produce no response, contact LaserLyte support or replace the unit.
You should see: You get a repair, replacement, or confirmation of a failed switch or internal part.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: Battery polarity markings, a fully seated battery cap, any flicker when the switch is toggled, and corrosion on contacts
Before you change anything: Remove batteries before cleaning contacts. Use the battery size the model specifies. Do not shine any laser toward eyes or aircraft. Stop if the housing is cracked or the unit smells burnt.