How do you fix wrist-turn screen activation on a GloryFit watch?
Answer
Turn Raise to wake or wrist-turn activation back on in the GloryFit app and on the watch, then wear the band snugly. Restart the watch if the sensor still does not respond.
Follow these steps
Enable raise-to-wake in the app
Open the GloryFit app, go to the device or watch settings, and turn on Raise to wake, Lift wrist to wake, or Wrist turn activation. Sync the change to the watch.
You should see: The setting shows On and the watch receives the update.
Check the on-watch display menu
On the watch, open Settings or Display and confirm any raise-to-wake or gesture option is enabled. Set screen timeout to a few seconds so you can see wake events.
You should see: The watch’s own raise-to-wake option is enabled.
Adjust how the watch is worn
Wear the watch snugly about one finger-width above the wrist bone, with the screen facing up. Try several deliberate wrist turns.
You should see: The screen wakes when you raise your wrist.
Restart watch and re-pair if needed
Restart the watch from its menu, force-close and reopen GloryFit, and reconnect Bluetooth. Re-enable raise-to-wake after reconnecting.
You should see: Wrist-turn activation works after the fresh connection.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: Lifting or turning your wrist does not wake the GloryFit screen, while tapping the screen still works.
Before you change anything: Charge the watch above 20%. Keep the phone Bluetooth on and the GloryFit app nearby. Note whether any recent app or firmware update occurred.